Mitsubishi Electronics SW1DNC-GXW2-E Instrukcja Użytkownika Pobierz pdf (Strona 106)

5 - 18

5.4.2 Batch monitoring of device values

5 CREATING TWO OR MORE PROGRAM BLOCKS

GX Works2

5.4.2 Batch monitoring of device values

Refer to the following section for the Batch monitoring of device values.

3.4.2 Batch monitoring of device values

5.5 Diagnosing the programmable controller

You can check the programmable controller RUN/STOP status and error status.

Refer to the following section for the diagnosis procedure:

3.5 Diagnosing the programmable controller

5.6 Reading a Project from programmable controller

Refer to the following section for the procedure to read a project from the programmable controller:

3.6 Reading a Project from programmable controller

6. Select [Online] [Monitor] [Stop Monitoring

(All Windows)] to reset the monitor status on all

monitored screens.

You can also click Stop Monitoring (All Windows)

to reset each monitored screens.

7. Set the programmable controller CPU to STOP.

Set the RUN/STOP switch on the programmable

controller CPU to "STOP".

You can switch the programmable controller status

between "RUN" and "STOP" using remote

operation.

"Point" in the step4

1 2 ... 101 102 103 104 105 106 107 108 109 110

Brak uwag

Mitsubishi Electronics SW1DNC-GXW2-E Instrukcja Użytkownika Strona 106